Changing The Battery; General Operations; Signal Sources; Teletext Operations - Telefunken TF-LED19S58T2 Instruction Manual

Operation

Changing the battery

1. Remove the battery compartment cover
on the back of the RC.
2. Insert the batteries into the battery
compartment making sure that the correct
polarity is observed.
3. Install the cover back.
1
• Use two AAA batteries for the RC. The RC
should be pointed at remote sensor within 8
meters and within 30 degrees at the left or the
right side.
• Take the battery out of the RC if it is not
used for a long time.
• Do not mix new and used batteries or
different types of batteries. Weak batteries can
leak and severely damage the RC.
• Do not expose the RC to shock, liquids,
and do not place it in an area with high
humidity.

General operations

Power
• Connect the plug of the power cord to the
mains socket.
• Do not leave your TV in standby mode for
a long period of time; if you are not going to
use the unit, disconnect it from power supply.
• In TV mode the unit will automatically go to
standby mode if no signal for 5 minutes.
Operations
• Press VOL- button repeatedly to decrease
the volume; press VOL+ button repeatedly to
increase the volume.
• Press MUTE to mute sound, press this button
again or increase volume to resume sound.
• Press RETURN button on the RC to select
from the present channel and the previously
displayed channel.
8
8
2 3
• Select the TV function mode. Press
CH-/CH+ buttons to select previous or next
channels; or press number buttons to enter a
channel number directly.
• Press INFO button to display the preset
TV channel play information.
• Press AUDIO button in TV mode repeatedly to
switch between various Nicam sound modes
(can be unavailable for some channels). This
function is optional.

Signal sources

Press the SOURCE button, then press
DOWN/UP cursor buttons on the RC or
CH+/CH- buttons on the panel to select a
source from available source list: DTV =>
ATV => AV => PC => YPbPr => HDMI
=> PC => USB. Press OK button on the
RC or VOL+ on the panel to confirm.

TELETEXT operations

• Select the TV source mode. Then press
CH-/CH+ buttons to select TV channel in order
to pick up the picture signal of Teletext.
• Press CH-/CH+ buttons to select the
previous page or the next page.
• Teletext button functions are as follows:
INDEX : press this button to go to the
index page.
Number buttons: enter the number of the
designated page directly.
REVEAL : press this button to reveal the
concealed information. Press this button again
to conceal the information.
press the 4 color buttons to
access directly to corresponding color page
displayed at the lower parts of teletext screen
p
p
only teletext + channel and
channel only
SIZE : press this button to enlarge the
text shown on the teletext screen, and one half
of page could be shown. Press this button
again to view the second half of this page.
Press this button third time to normal size text
page view.