Mounting - Boss MC470B User Manual

Mounting

See the section "Installation Precautions" on page 2.
Keep connection cables away from any pinch points, moving parts, or any hot exhausts.
Do not install the speakers where they may obstruct the rider's view or inhibit any safety
features on the vehicle (e.g. lights, horns, brake levers, etc.).
Before you drill any holes, investigate your vehicle's layout very carefully. Take special
care when you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
To ensure security of the mounted speakers, always check the mounting conditions (e.g.
clamp fastening) of the speakers before each vehicle ride.
Mounting the speaker pods
1.
Find a safe and ideal mounting location on the handlebar. Make sure the speakers will not
obstruct the rider's view or any safety features.
2.
The supplied clamp is pre-attached to the bottom of the speaker. Unfasten the clamp through the
mounting nuts.
3.
Fit the clamp around the handlebar of your vehicle. Remember to attach the supplied rubber
shims over the mounting bar to secure clamping and prevent abrasion.
4.
Re-fasten the mounting nuts to tighten the clamp. Before fully tightening, adjust the speaker so it
points directly at the rider.
a
a
a.
Mounting nut
b.
Rubber shim
c.
Speaker clamp
d.
Mounting bar (0.75" - 1.25" in diameter)
d
b c
- 3 -