GE Profile PYE22PSKSS Owner's Manual And Installation Instructions page 44

Before you call for service...
Troubleshooting Tips (cont)
Problem
Beverage quality not as expected
Liquid drips from the brewer after
brewer cycle is completed and the
brewer is removed from the bracket
Delay when using Keurig K-cup Pod
dispenser
After brewing, my powdered beverage
is not fully cleared from the used pod
Brewer lid is difficult to close
Brewer leaks during the brew cycle
*Select Models Only
44
Possible Causes
You may be using non-standard or
out dated K-Cups
It is possible for liquids to be retained
by the brewer and drip when it is
removed
To ensure a quality beverage is
delivered, a short delay is required to
ensure the refrigerator is operating
correctly
Depending on size selected, the
powder may not dissolve fully. Some
powdered beverages develop into
'clumps' when left sitting for some
time
K-cup is not fully seated
Trouble in closing brewer lid or
damaged K-cup
What to Do
Recommend using official Keurig K-cups
that are not past expiration and have not
been damaged
Use a cloth or container to capture the
drips when brewer is removed
Ensuring consistent, quality operation
requires the refrigerator to delay dispense
for a short period of time
Shake the powdered pods before brewing
to break up these clumps and allow better
clearing. For powdered beverage with no
filter, use the Cocoa cycle selection
Press K-cup all the way down into the
brewer prior to closing the lid. Lower
needle must puncture K-cup bfore closing
the brewer lid
Press K-cup all the way down into the
brewer prior to closing the lid. Lower
needle must puncture K-cup bfore
closing the brewer lid. Recommend using
official Keurig K-cups that have not been
damaged and have a good seal between
the top cover and plastic bottom