Daikin FTXM20M2V1B Operation Manual page 39

FTXM50M2V1B/FTXM60M2V1B/FTXM71M2V1B
■
Titanium apatite photocatalytic air-purifying fi lter
1.
Open the front panel and
pull out the air fi lters.
2.
Take off the titanium
apatite photocatalytic air-
purifying fi lters.
• Remove the fi lters from the tabs.
Claw Claw
3.
Clean or replace the
titanium apatite
photocatalytic air-
purifying fi lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the fi lter to remove water from it.
[Replacement]
Remove the fi lter from the tabs
Page 34 and prepare a new one.
• Dispose of the old fi lter as non-fl ammable waste.
4.
Insert the titanium apatite
photocatalytic air-
purifying fi lters as they
were.
• When attaching the fi lter, check that the fi lter is
properly set in the tabs.
5.
Reattach the fi lters.
6.
Close the front panel
slowly.
NOTE
• Operation with dirty fi lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old fi lters as non-fl ammable waste.
• To order a titanium apatite photocatalytic air-purifying fi lter, contact
the dealer where you bought the air conditioner.
Page 36
Page 36
38