Pride Mobility Jazzy Select Series Owner's Manual page 15

Seat Installation (Select 6 with Power Seat
only)
It may be necessary to install the seat either prior
to initial operation or after transporting your power
chair. Most seats are attached to the power base with
the Universal Mounting System (UMS). The UMS
consists of universal parts that may be attached to
any medium-back or high-back seat, regardless of
seat width or seat depth. The two main components
are aluminum extrusions mounted to the seat base.
These extrusions attach to a pair of trapeze bars that
are mounted to the power base. See figure 10.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do.
To install the power seat:
1. Tilt the seat back and slide the rear extrusion onto
the power base.
2. Lower the front extrusion onto the power base
until the seat latches into place.
3. Flip down the seat latch safety. See figure 11.
4. Connect the power seat connector to the power
base. See figure 10.
5. Lift the armrest straight up, then route the
controller harness and secure with wire ties as
shown in figure 12.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY!
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in
the seat frame, or damaged when
passing through doorways.
6. Plug the controller harness into the connector on
the power base. See figure 4.
NOTE: Refer to V. "Comfort Adjustments" for
more information on controller installation and
adjustment.
Jazzy Select Series
I V. A S S E M B L Y
Prevent controller
www.pridemobility.com
Identification Key
1. Rear Extrusion
2. Seat Latch Safety
4
Figure 10. Universal Mounting System on Select 6 with
Power Seat
3. Front Extrusion
4. Power Seat Connector
1
2
3
15