Table of Contents
Advertisement
DLP Projector—User's Manual
Rear view
I
L
TEM
ABEL
1.
HDMI 1
2.
RJ45
3.
HDMI 2
4.
HDBaseT
5.
HDMI 3 / MHL
6.
MONITOR OUT
7.
COMPUTER
8.
VIDEO
9.
3D-SYNC
10.
SERVICE
11.
USB POWER (5V/1.5A)
12.
Kensington Security Slot
13.
IR
14.
AUDIO IN L/R
15.
MIC IN
D
ESCRIPTION
Connect the HDMI cable from an HDMI device.
Connect a LAN cable from Ethernet.
Connect the HDMI cable from an HDMI device.
Connect Cat5e/Cat6 cable from HDBaseT TX Box (VIDEO
EXTENDER) for HDBaseT signal received.
Connect the HDMI/MHL cable from an HDMI/MHL device.
Note: Set the Source to HDMI 3/MHL also can be charging connected
MHL compatible smart device as long as the projector Power
On.
Connect an RGB cable to a display.
Connect an RGB cable from a computer or a video enabled device.
Connect the composite cable from a video device.
Connect 3D-sync in cable from a computer or an enabled device.
For service personnel only.
Connect a USB cable for USB host.
Note: Support 5V/1.5A output as long as the projector Power On.
Secures to permanent object with a Kensington Lock
system.
Receive IR signal from remote control.
Connect the audio cables from an audio device for VIDEO audio input.
Connect the microphone input device.
— 4 —
S
EE PAGE
58
Advertisement
Table of Contents
