Power Save Mode; Error Warning - Sharp ER-A520 Instruction Manual

Procedure
■ Sign-on
Variant 1 :
(Code is displayed.)
Variant 2 :
(Code is not displayed.)
• If you want to enter a cashier/server code before every transaction, please consult your authorized
Note
SHARP dealer.
• For the display type selection of the cashier/server code, "Variant 1" has been preset. For the
selection of the "Variant 2", consult your authorized SHARP dealer.
• The cashier/server can be changed during a transaction. Please consult your authorized SHARP
dealer.
2

Power save mode

The register will enter into the power save mode when no entries are performed based on the pre-programmed
time limit (by default, 30 minutes).
When the register goes to the power save mode, the operator and customer displays will turn off. This is
indicated by a decimal point at the left most position of the lower line. The register will return to normal operation
mode when any key is pressed or a mode is changed with the mode key. Please note when the register is
recovered by any key entry the initial key entry is ignored. After the recovery, you may start the key entries from
the beginning.
3

Error warning

In the following examples, your register will go into an error state accompanied with a warning beep and a
corresponding error message. Clear the error state by pressing the
Please refer to the error message table on page 223.
• When you enter an over 32-digit number (entry limit overflow): Cancel the entry and re-enter a valid number.
• When you make an error in key operation: Clear the error and continue entries.
• When you make an entry beyond a programmed amount entry limit: Check to see if the entered amount is
correct. If it is correct, it be possible to make the entry in the MGR mode. Contact your manager.
• When an including-tax subtotal exceeds eight digits: Clear the subtotal by pressing the
Å É
a k
, thru ,
To display the current cashier/server code
Cashier/server
code
‹ ‹
/
SERV
h
, thru , or
CHK2 CHK5
‹ ‹
/
SERV
‹ ‹
Cashier/server
code
thru key to finalize the transaction.
CH9
■ Sign-off
Variant 1 / Variant 2 :
‹ ‹
/
SERV
/
SERV
c
key and take proper action.
c
‹ ‹
/
SERV
key and press the
21