Sharp HT-SB500 Operation Manual page 21

General control (continued)
Subwoofer level control
The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL button.
To decrease the level, press the
SUBWOOFER LEVEL button.
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
Center speaker level control
The center speaker level can be adjusted.
To increase the level, press the CENTER
SPK LEVEL button.
To decrease the level, press the CENTER
SPK LEVEL button.
Bass control
1. Press the BASS/TREBLE button
to select "BASS".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
Treble control
1. Press the BASS/TREBLE button
to select "TREBLE".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
Touch Sensing off mode
During Stand-by mode, press the DIMMER/SENS ON/OFF button
on the remote control and the STAND-BY indicator will turn from
ORANGE to RED.
To turn the power on, press the ON/STAND-BY button on the remote
control or touch the ON/STAND-BY pad on the display panel.
Function
On the speaker:
When the FUNCTION pad on speaker
is touched, the input source will change.
Touch the FUNCTION pad on speaker
-5 -4 ... +4 +5
repeatedly to select desired input
source.
On remote control:
Press the LINE 1-2 button repeatedly to
select "L1" (LINE IN 1 input) or "L2"
(LINE IN 2 input).
Press
repeatedly to select "D1" (DIGITAL IN 1
input) or "D2" (DIGITAL IN 2 input).
-5 -4 ... +4 +5
Note:
The backup function will protect the memorized function mode
for a few hours should there be a power failure or the AC power
cord becomes disconnected.
Auto power on function:
When you press the LINE 1-2 or DIGITAL 1-2 button on the
-5 +5
remote control, the speaker will turn on at last function.
Auto power off and auto detect signal:
If no analogue signal is detected within 1 minute or if "D1"/
"D2" display is blinking and after 30 seconds during power on,
the speaker will automatically go to stand-by mode. The
STANDBY indicator turns orange.
The speaker will automatically power ON if it detects audio
-5 +5
signal from connected equipment.
Note:
Make sure to turn off any source/signal input to speaker before
going to stand-by mode because it will cause the speaker to
power ON again.
the DIGITAL 1-2 button
HT-SB500
LINE 1
LINE 2
DIGITAL 1
DIGITAL 2
21