Zanussi ZCG91246 User Manual page 13

Put the tray or deep pan on the shelf position.
Make sure it does not touch the back wall of the
oven.
Using the turnspit
WARNING!
Be careful when you use the
turnspit. The forks and the spit are
sharp. There is a risk of injury.
WARNING!
Use oven gloves when you remove
the turnspit. The turnspit and the grill
are hot. There is a risk of burns.
CAUTION!
The maximum weight permitted on
the turnspit is 4.5 kg.
A
A) Support hook
B) Forks
C) Spit
D) Handle
The support hook is installed in the
top of the oven cavity.
You can leave the support hook in
the oven, when the turnspit is not
active.
1. Open the oven door.
2. Put the turnspit handle into the spit.
3. Put the baking tray on the lowest shelf level.
4. Snap out one end of the support hook from
the oven ceiling A and let it hang on the
other end.
A
www.zanussi.com
B
C
D
5. Install the first fork on the spit, then put the
meat on the turnspit and install the second
fork.
Make sure that the meat is in the middle of
the spit.
6. Use the screws to tighten the forks.
7. Put the tip of the spit into the turnspit hole.
Refer to "Product description" chapter.
8. Put the front part of the spit on the support
hook.
9. Remove the turnspit handle.
10. Light the grill.
Refer to "Oven - Daily use" chapter.
11. Press the turnspit button
12. Make sure that turnspit rotates.
13. Close the oven door.
The turnspit does not stop if you open the
oven door.
When meat is ready press the turnspit button.
Turn off the grill. Install the turnspit handle.
Carefully remove the turnspit and the roasting
pan from the oven.
.
13