Installing System Memory - Sony PCV-MXS20 - Vaio Desktop Computer System Reference Manual

Removing, Installing, and Replacing Components

Installing System Memory

!
Before opening the system unit, save and close all open files, exit all open
applications, turn off the power to all attached peripheral devices, shut
down the computer, and unplug the power cord.
1
Choose the size of the memory module and configuration as shown
in the following table. Memory modules can vary in size and speed
between sockets. The minimum memory size is 8 MB. The maximum
memory size is 1 GB. The BIOS automatically detects the type, size
and speed of the memory modules.
Memory module configurations (MB)
DIMM1
128, 256, 512
* Your computer ships with at least 512 MB of memory. DDR-SDRAM is
expandable to 1 GB. Your model may ship with more than 512 MB
DDR-SDRAM, depending on the system configuration you purchased.
✍
Use only PC2100 memory. Your system does not support EDO or buffered
DDR-SDRAM, or PC100/133 SDRAM memory modules.
2
If necessary, remove the memory module you wish to replace (see
"Removing a Slot Cover"
!
Touch any exposed metal part of the chassis to discharge static
electricity in your body before handling a memory module.
3
Remove the new memory module(s) from its anti-static package.
Hold the memory module only by its edges to prevent static-
electricity damage.
4
Remove the side cover (see
5
Remove the power supply (see
page 48).
6
Remove the screw that secures the AGP add-in card to the chassis.
7
Press down on the handle at the edge of the AGP slot.
*
DIMM2
128, 256, 512
on page 41).
"Removing the Side Panel"
"Removing the Power Supply"
37
on page 26).
on