Operation - Breville AquaStation Hot Instruction Book

Operation

OPERATING YOUR
AQUASTATION™ HOT
1. Ensure the upper pre-filtered water tank is
assembled inside the lower filtered water
tank, and that the water filter cartridge is
correctly fitted into position.
2. Plug into a 230/240V power outlet. The
will beep, the water droplet light will flash 3
times, the LCD screen will illuminate, and
AMBIENT will display on the LCD screen
to indicate the is in standby mode.
3. Use the pull ring at the back of the water
tank to assist in lifting it up and away from
the base of the . Fill the pre-filtered water
tank with cold tap water to the MAX level.
Never fill past the MAX level. Once water
has filtered into the filtered water tank, top
up the tanks until the water level is set to
the MAX level.
4. Ensure the water tanks are assembled to
the and place a cup of choice onto the drip
tray, or alternatively, remove the drip tray to
accommodate large glasses.
NOTE
Always ensure the water tanks are filled to the
MAX level for optimum flow of water from the
spout. Ensure the water tanks are filled above
MIN water level, or as soon as the FILL TANK
alert appears on the LCD display.
If the water level falls below the MIN tank
marking, the water sensor will automatically
stop dispensing and the Fill Tank indicator will
appear on the screen.
Regularly check and discard any water that
might accumulate in the drip tray.
TURNING OFF THE UNIT
Turn off at the power outlet.
16
IMPORTANT
Turning the off at the power outlet will delete
the 'last setting' memory function.
NOTE
Discard any filtered water that has been left
sitting for several days or more. This will
ensure you have cleaner, great-tasting water.
If your filter has been unused for a long period
of time, it is recommended to resoak the filter
for 10 minutes before use and clean the water
tanks as per the cleaning instructions found in
this book.
STANDBY MODE
When the unit is plugged into the power outlet,
the water droplet light will flash 3 times, the
display screen will illuminate and AMBIENT
will appear on the display screen to indicate
the is ready for use.
The will automatically go into energy-saving
standby mode after 5 minutes if not used.
The water droplet light will turn off when in
standby mode.
To awaken the , press any button or press/turn
the FUNCTION dial once; one long beep will
sound, the water droplet light will illuminate
white and flash rapidly 3 times to indicate that
the is ready to use.