Breville Hot Cup Instructions For Use Manual

Breville Hot Cup Instructions For Use Manual

Hide thumbs Also See for Hot Cup:

Advertisement

Actual product may differ from the one illustrated

Advertisement

Table of Contents
loading

Summary of Contents for Breville Hot Cup

  • Page 1 Actual product may differ from the one illustrated...
  • Page 2: Important Safety Instructions

    Important Safety Instructions READ CAREFULLY AND KEEP FOR FUTURE REFERENCE This product can be used by children aged 8 years and above, and persons who require supervision, provided: • they are familiar with the hazards associated with the product, and, •...
  • Page 3 Important Safety Instructions !This appliance generates heat during use. Adequate precaution must be taken to prevent the risk of burns, scalds, fires or other damage to persons or property caused by touching the exterior whilst in use or during cooling. !Never use this appliance for anything other than its intended use.
  • Page 4: Identifying The Parts

    5. Start button Press to start the boil sequence. 6. Dispensing control This control allows you to select the amount of water dispensed by your Hot Cup. Move it towards for less water or for more water. 7. Lid 8.
  • Page 6 Fill the water reservoir from your cold tap. The water level should be between the MIN and MAX markings. Close the lid and press the stop button. This will make sure that your hot cup will not immediately start a boil cycle when you place it onto the power base.
  • Page 7 SMALL LARGE...
  • Page 8: Emptying Your Hot Cup

    Repeat steps 3 and 4 until all the water has been emptied from your Hot Cup. If your Hot Cup will not be used for an extended period (e.g. if you are on holiday), we recommend that you first empty it. Before using your Hot Cup again, carry out several boil cycles discarding the water each time.
  • Page 10: Descaling Using Proprietary Descaling Product

    30g of the citric acid with 500ml of water. 3. Pour the solution into your Hot Cup, close the lid and allow it to stand for 1 hour. 4. Cycle your Hot Cup (as described in steps 4-6 above) until the level is at the MIN mark.
  • Page 12: Troubleshooting

    Possible Cause Solution The start switch will not stay Your Hot Cup has not reset Your Hot Cup is still too hot in the on position. itself after the boiling cycle. after the last boil cycle. Wait a few seconds for it to cool slightly before trying again.
  • Page 13: Connection To The Mains Supply

    Connection to the mains supply This appliance is fitted with either a moulded or rewirable BS1363, 13 amp plug. The fuse should be rated at 13 amps and be ASTA approved to BS1362. If the fuse in a moulded plug needs to be changed, the fuse cover must be refitted. The appliance must not be used without the fuse cover fitted.
  • Page 14: After Sales Service

    After sales service These appliances are built to the very highest of standards. There are no user serviceable parts. Follow these steps if the unit fails to operate: Check the instructions have been followed correctly. Check that the fuse has not blown. Check that the mains supply is functional.
  • Page 15 Guarantee Please keep your receipt as this will be required for any claims under this guarantee. This appliance is guaranteed for 1 year after your purchase as described in this document. During this guaranteed period, if in the unlikely event the appliance no longer functions due to a design or manufacturing fault, please take it back to the place of purchase, with your till receipt and a copy of this guarantee.
  • Page 16 The product you buy may differ slightly from the one shown on this carton due to continuing product development. One (1) Year Limited Warranty—see inside for details. Jarden Consumer Solutions (Europe) Limited is a subsidiary of Jarden Corporation (NYSE: JAH). Made in PRC www.breville.co.uk P .N. 165481 93027-3 VKJ318_VKJ784_Iss_4...

Table of Contents