Breville AquaStation Hot Instruction Book page 14

90d
3x
3 beeps will sound and the water droplet light
FILTER RESET
90d
will flash continuously in red.
MAX
MAX
MIN
MIN
FILTER RESET
90d
1. Lift the water tank from the unit, remove the
lid and set aside. Lifting by the ring, remove
the filter cartridge from the filter holder
MAX
and discard any remaining water inside the
water tanks, then separate the upper tank
NEW FILTER
MIN
from the lower tank.
10m
SHAKE FILTER
NEW FILTER
FILTER RESET
90d
SHAKE FILTER FILTER RESET
90d
NEW FILTER
MAX
2. Remove the new filter cartridge from its
10m
SHAKE FILTER packaging.
MIN
NOTE
MAX
It is normal for the filter to appear moist when
MIN
removed from its wrapping. This is
condensation from the hygienic steam
NEW FILTER
sterilisation process.
10m
SHAKE FILTER
NEW FILTER
1L
10m
SHAKE FILTER
3. Immerse the filter in a bowl of tap water and
gently shake until there are no air bubbles.
Soak filter in the tap water for 10 minutes.
MAX
1L
MIN
FUNCTION
FILTER RESET
4. Once soaked, insert the filter into the filter
1L
MAX
holder of the upper tank and push down
firmly to secure in place.
MIN
14
1L
FUNCTION
FILTER RESET
MAX
10m
FILTER RESET
NEW FILTER
90d
NEW FILTER
MAX
10m
SHAKE FILTER
MIN
10m
SHAKE FILTER
MAX
NOTE
MIN
Make sure the filter is tightly fitted. If the filter
is not pressed in tightly, unfiltered tap water
may flow around the filter into the lower water
NEW FILTER
tank, or the filter may float up.
10m
SHAKE FILTER
NEW FILTER
10m
SHAKE FILTER
5. Place the upper tank into the lower tank.
1L
1L
6. To flush and activate the new filter
MAX
cartridge, add 1L of water to the upper water
tank, allowing the water to filter through.
MAX
MIN
Remove the water tanks and discard the
MIN
collected water. Repeat this step once more
FUNCTION
1L
so the filter is fully flushed with 2L of water
FILTER RESET
before use.
FUNCTION
FILTER RESET
1L
MAX
MIN
MAX
7. Once flushed, fill the water tank with tap
FUNCTION
water up to the MAX line.
MIN
FILTER RESET
FUNCTION
FILTER RESET
8. Press the "HOT" button once. Turn the
FUNCTION dial until the indicator reaches
FILTER RESET, then press the FUNCTION
dial once to reset the filter counter. FILTER
RESET will no longer appear on the screen.
9. The is now ready to use.