Midea MRF29D6AST User Manual page 16

Filter element time reset
Hold down
Celsius transformation
Long press the
Forcing AP mode
Long press
the refrigerator to AP mode and display AP in the temperature display area.
After the module enters AP mode successfully, it automatically exits AP mode,
and the temperature display area restores to normal temperature display.
Sabbath mode
Press
Sabbath mode.
If the refrigerator is connected to the Internet, you can enter or exit the
Sabbath mode through the corresponding function buttons in the SmartHome
refrigerator control interface, and the
6
buzzer does not sound, the door opening lamp does not light up, and the
EN
distributor only displays the selected function in low brightness.
Anti-condensation heating element on/off mode.
Press the
press the button
function is successfully set.
Under the above settings, unlock and enter again, continue to press the and
to release the anti-condensation heating element off function.
Open door prompt sound switch
• At the same time, press
close or open the door prompt tone.
ATTENTION
• If the fridge section or freezer drawer is not closed after power-on, the app or
refrigerator will give an alarm. It will call three times after exceeding 2 minutes, and then
add one alarm every 1 minute.
3
for 3
the
after entering the Sabbath mode lock, the display goes out, the
, and the anti-condensation heating wire shutdown
for 4 , the
and
to achieve Celsius Fahrenheit conversion
to forcibly set the wireless network module of
and for 3
can select the automatic exit time.
icon no longer flashes, press the button
button 4 seconds to activate or deactivate,
16
to enter or exit the