Advertisement
RED TIME-SET
BUTTON
1)
Press and hold the red button in to disengage the drive gear.
2)
Turn the large gear until the actual time of day shows in the time of day window. Unit will now be set to backwash at 1:00 a.m. (See note below to adjust
the time).
3)
Release the red button to again engage the drive wheel.
If you are setting the Time Control after Midnight but before Noon, the red pointer on the Skipper Wheel must be between two numbers (as shown). If you are
setting the Time Control after Noon, but before Midnight, the red pointer must be covering one of the numbers. Setting the Skipper Wheel in this manner will
provide a 1:00 a.m. Backwashing time.
If directions above on How To Set The Skipper Wheel are not followed, Backwashing will not take place at the appropriate time of day.
Set the days that backwash is to occur by sliding tabs on the skipper wheel outward to expose trip fi ngers. Each tab is one day. Extend or retract fi ngers to ob-
tain the desired backwashing schedule. Typically, these units are backwashed every third day. Consult your dealer for their recommendations for your water.
Turn the manual backwash knob clockwise until the knob engages the program wheel. This slight movement of the knob will start the backwash program.
The backwash knob will make one revolution in approximately 1 1/2 hours and stop in the position shown in the drawing. Even though it takes 1 1/2 hours for
the knob to complete one revolution, the backwash cycle of your unit might be about 20 minutes in duration.
In any event, fi ltered water may be drawn after rinse water stops fl owing from the fi lter drain line.
Should it be necessary to change the time of day which backwash is to start, the time on 12 hour gear must be altered. For example, if 2:00 a.m. is desired
instead of 1:00 a.m., set the 12 hour gear one hour earlier than actual time.
HOW TO SET TIME CONTROL
MANUAL BACKWASH
KNOB
SERVICE
TO SET TIME OF DAY - PRESS RED
BUTTON AND TURN LARGE GEAR UNTIL
PRESENT TIME APPEARS ABOVE ARROW.
FOR MANUAL REGENERATION TURN KNOB
CLOCKWISE TO REGEN. POSITION.
TIME OF DAY
ARROW
How To Set Time Of Day
How To Set The Skipper Wheel
IMPORTANT NOTE
IMPORTANT NOTE
How To Set Days On Which Filter Is To Backwash
How To Manually Backwash Your Filter At Any Time
IMPORTANT NOTE
IMPORTANT NOTE
12 HOUR GEAR
12
DAY
TIME OF
RED POINTER
2-4
SKIPPER WHEEL
(SHOWS EVERY DAY
REGENERATION)
Advertisement
