Table of Contents
Advertisement
SENSORS
Cyclone Sensor Mounting
Flexible Installation
Hand Screw
Install the Hand Screw to the bracket, then Secure
the Cyclone Sensor to the Mast by tightening the
screws on the side.
Advanced Installation
Some advanced installation options include tripods, wall mounts, chimney mounts, and many others.
Any of these can be combined with U-bolts for attachment onto a tall cylindrical conduit using our
Adjustable Base. These options will require additional equipment and possibly professional help for
best results.
Freestanding Pole Setup
1'' Maximum Outside
Pole Diameter
24
This configuration allows you to attach the sensor
to angled locations and easily make adjustments
to ensure the Mast and Sensor are level.
Tripod Setup Example
1'' Maximum Outside
Pole Diameter
SENSORS
Cleaning the Rain Sensor
1.
Remove the Rain Funnel by firmly twisting
the funnel counter-clockwise and lifting up.
3.
After cleaning, re-install the Rain Funnel by
placing it back into the sensor and twisting
clockwise until secure.
Tip:
Remove the Cyclone Sensor's batteries before cleaning to avoid accidental rain readings.
2.
Clear any leaves, insects, or other debris to
allow the Rain Tipper to rock freely. Check
and clear the Drainage Holes located on
the underside of the sensor.
4.
You should feel the funnel lock into place
when one of the arrows lines up with the
center of the Lock/Unlock Line.
25
Advertisement
Table of Contents
