Positioning And Levelling; Water Inlet - Electrolux LAVAMAT 74950 W User Manual

6. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag contain-
ing the instruction booklet.
7. Connect the water inlet hose as descri-
bed under the paragraph «Water inlet».

Positioning and levelling

Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor
by putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the ma-
chine next to a gas cooker or coalburning stove,
an insulating panel covered with aluminium foil
on the side facing the cooker or stove, must be
inserted between the two appliances.
The machine must not be installed in rooms where the temperature can drop below 0°C.
The water inlet hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it is easily accessible for the engineer
in the event of a breakdown.
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or
similar materials under the machine to compensate for any unevenness in the floor.

Water inlet

An inlet hose is supplied and can be found inside the machine drum.
This appliance must be connected to a cold water supply.
Do not use the hose from your previous machine to connect to the water supply.
33
Installation