Installation; Unpacking; Positioning And Levelling; Water Inlet - Electrolux EW 1280 F Instruction Booklet

Installation

Unpacking

All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
P1129
2. Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by
placing one of the corner packing pieces between
the machine and the floor.
3. Remove the polystyrene block(s) from the bottom
of the machine. Unscrew and remove the four
feet. Release the two plastic bags.
4. Very carefully slide out the left polythene bag,
removing it towards the right and then downwards.
1
2
3
P1123
5. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.
6. Fit the grid (A) on the bottom of the machine
using the four screws (B) you will find in the bag
containing the instruction booklet.
Re-fit the feet.
P1127
P0001
P1126
B
B
A
B
B
P1067
7. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
8. Plug all the holes with the plugs which you will
find in the envelope containing the instruction
booklet.
P1128

Positioning and levelling

Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
P1051

Water inlet

Connect the machine to a cold water tap with a 3/4"
thread by means of the water inlet hose situated at
the back of the appliance. Do not use to this purpose
old hoses already employed
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
P1088
7
P0002
P0021