Thank you for choosing this product. WEEE contains both polluting substances (which We are proud to offer the ideal product for can cause negative consequences for the you and the best complete range of home environment) and basic components (which can appliances for your daily routine.
1. GENERAL SAFETY in a safe way and understand the hazards involved. RULES Children shall not play with the This appliance is intended to appliance. Cleaning and user be used in household and maintenance shall not be made similar applications such as: by children without supervision.
Page 4
Items such as foam rubber WARNING: (latex foam), shower caps, never stop a washer dryer before waterproof textiles, rubber the end of the drying cycle backed articles and clothes or unless all items are quickly pillows fitted with foam rubber removed and spread out so that pads should not be dried in the the heat is dissipated.
Page 5
To consult the product technical Do not pull on the power cord specification please refer to the or appliance to unplug the manufacturer website. machine. Make sure there is no water in Electrical connections the drum before opening the safety instructions door.
2. INSTALLATION Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. If the washing machine is built- ...
Page 7
Instructions for mounting the furniture door Position the template onto the reverse of the furniture door. It is possible to mount the hinges and closure magnet on the right or left-hand side depending on your requirements. Mark the screw hole positions, then drill out these positions.
Page 8
Mount the furniture door to the front of the washer using the hinges. Fix the spacers (I) in place with the 2 screws (J) and then fix the hinges with 2 screw (H). We suggest mounting the furniture door so that it opens towards the left, which is the same direction as the porthole door.
Page 9
Hydraulic connections Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do reuse old hose-sets). SOME MODELS may include one or more of the following features: HOT&COLD (fig. 4): ...
Page 10
Setting The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support.
3. DETERGENT DRAWER WARNING: detergent draw split into some detergents are not designed for compartments as illustrated in figure 9: use in the dispenser drawer but are supplied with their own dispenser that compartment "1": for prewash detergent; is placed in the drum directly. compartment “...
4. PRACTICAL HINTS Maximise the load size Achieve the best use of energy, water, Load tips detergent time using recommended maximum load size. When sorting laundry, make sure: Save up to 50% energy by washing a full load instead of 2 half loads. - have eliminated metallic objects such as hair clips, pins, coins, from laundry;...
Page 13
The use of ecological detergents without When washing heavily soiled whites, phosphates cause following we recommend using cotton programs of effects: 60°C or above and a normal washing powder (heavy duty) that contains - cloudier rinse drain water: This effect is bleaching agents that at medium/high tied to the suspended zeolites which do temperatures provide excellent results.
5. CLEANING AND Remove and clean the filter; when finished, replace it turning it clockwise. MAINTENANCE The filter handle will be locked when it is not possible to turn any further and the Looking after your appliance correctly can handle is horizontal.
6. QUICK USER GUIDE 7. CONTROLS AND PROGRAMMES This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. Program selection Turn on the washing machine and select ...
Page 16
START/PAUSE button WARNING: Don’t touch the display while inserting Close the door BEFORE selecting the plug because machines button START/PAUSE. calibrates the systems during the first seconds: touching the display, the machine couldn’t work property. In Press to start the selected cycle. ...
Page 17
To delay the start use the following washing programme compatible with automatic drying procedure: selected, this function will not be activated. - Select the required programme. If you exceed the maximum dryable - Press the delay start button once to load of laundry indicated in the activate it (h00 appears on the display) programme table, the laundry may not...
Page 18
water is filled and emptied, will give you RAPID / STAIN LEVEL button garments which have been cleaned and rinsed to perfection so that the detergent This button allows you to choose between dissolves completely, ensuring two different options, depending on the efficient cleaning action.
Page 19
Digital Display To prevent damage to the fabrics, it is not possible to increase the speed The display’s indicator system allows you to over the maximum allowed for the be constantly informed about the status of programme. the machine. To reactivate the spin cycle press the button until you reach the spin speed you would like to set.
Page 20
Wi-Fi, please refer to the "Download" section on Timed drying programmes http://wizardservice.candy-hoover.com. They may be used to select timed 7) STAIN LEVEL INDICATOR LIGHT drying programmes. The indicator light shows the selection of the relevant option.
Page 21
the data transfer to be successful, it is your device. essential TO KEEP THE SMARTPHONE ON THE DASHBOARD DURING THESE The Hoover Wizard App is available for SECONDS devices running both Android and PROCEDURE; a message on the iOS,...
Page 22
Table of programmes (MAX.) PROGRAMME (see control panel) (MAX.) 90° COTTONS 60° ECO 40-60 WASH AND DRY (ECO 40-60 + WOOL & HAND 30° WASH 20° 20°C 60° MIXED DRAIN & SPIN RINSE 40° SOFT CARE 30° RAPID CARE 3) 4) 30°...
Page 23
Please read these notes: INFORMATION FOR THE TEST Maximum load capacity of dry clothes, LABORATORIES according to the model used (see control panel). STANDARD PROGRAMMES ACCORDING TO Only with PREWASH option Directive 96/60/CE selected (programmes with PREWASH option available). WASHING: ECO 40-60 PROGRAMME When a programme is selected,...
Page 24
ECO 40-60 Description of programmes The ECO 40-60 programme is able to clean normally soiled cotton laundry declared to To clean different types of fabrics and be washable at 40°C or 60°C, together in various levels of dirt, the washing machine the same cycle.
Page 25
RINSE during the last 10/20 minutes of the drying This program performs 3 rinses with an cycle to minimize creasing. intermediate spin (which can be reduced or DRY WOOL excluded by using the appropriate button). It Low temperature drying programme, ideal is used for rinsing any type of fabric, for to dry woollen clothes with maximum care example after a wash carried out by hand.
8. DRYING CYCLE The correct way to dry Drying guidance advice is general, but Open the door. practical experience of using the product will help you to achieve the best drying results. Fill with the laundry, not exceeding the ...
Page 27
If you wish to select a timed drying The drying programme indicator will be DRYING programme, press on, until the cool down phase begins and SELECTION button until the required the corresponding indicator is on. time indicator lights up. When the programme is finished the word ...
9. AUTOMATIC If you wish to select a timed drying programme, press DRYING WASHING/DRYING SELECTION button until the required CYCLE time indicator lights up. Press the START/PAUSE button. You cannot exceed the maximum dryable load of laundry indicated in At the end of the wash phase the display ...
10. TROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT Models with a display: the error is shown by a number preceded by the letter “E” ...
Page 30
OTHER ANOMALIES Problem Possible causes and practical solutions The washing machine Make sure the product is plugged into a working supply socket. Make sure power is on. does not work / start Make sure the wall socket is working, testing it with another appliance such as a lamp.
Page 31
It is always recommended to use original By placing the mark on this spare parts, that are available at our product, we are confirming compliance Authorised Customer Service Centres. to all relevant European safety, health and environmental requirements which are applicable in legislation for this Warranty product.