Technical Support(Faq) - AOC Spectrum 7Elr+ User Manual

TECHNICAL SUPPORT (FAQ)
Problem & Question
Power LED is not on
No Plug & Play
No picture
Picture is fuzzy
Picture bounces or a wave
pattern is present in the picture
Monitor is stuck in "Power
Saving Mode"
Missing one of the primary
colors (RED, GREEN, or
BLUE)
Possible Solution
*Check if the Power Switch is in the ON
position
*Power Cord should be connected
*Check if the PC system is Plug & Play
compatible
*Check if the Video Card is Plug & Play
compatible
*Check if the D-15 plug pin of Video Cable
is bent
*Make sure the AOC Monitor Drivers are
installed
(AOC Monitor Drivers are available at:
www.aoc-europe.com)
*Computer Power Switch should be in the
ON position
*Computer Video Card should be snugly
seated in its slot
*The Signal Cable should be completely
connected to the computer
*Check the color of the Power LED
indicator. If it is orange, then the monitor
and the PC system are in power-saving
mode. You need press your keyboard or
move the mouse to reactivate the
system.
*Adjust the Contrast and
Controls.
*Move electrical devices that may cause
electrical interference.
*Make sure monitor's video cable is
properly connected to the computer.
*Inspect monitor's video cable and make
sure none of the pins are bent.
*Make sure computer is operational by
hitting the CAPS LOCK key on the
keyboard while observing the CAPS
LOCK LED. The LED should either turn
ON or OFF after hitting the CAPS LOCK
key.
*Inspect the monitor's video cable and
make sure that none of the pins are
bent.
10
Brightness