Table of Contents
Advertisement
Verifying the installation
Before powering on the device, verify that:
The correct power source is used.
•
The grounding cable is securely connected.
•
The console cable and power cord are correctly connected.
•
All the interface cables are cabled indoors.
•
Powering on the device
1.
Power on the device. The device initializes its memory and runs the BootWare. The following
information appears on the terminal screen:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Press Ctrl+T to start heavy memory test
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing.....Done!
****************************************************************************
*
*
*
****************************************************************************
Compiled Date
CPU Type
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
cfa0 Size
CPLD1 Version
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
2.
Press Ctrl + B at the prompt within 4 seconds to access the Boot menu. Otherwise, the system enters
the system image file reading and self-compressing process.
To access the Boot menu after the system enters the system image file reading and self-compressing
process, restart the device.
Starting to get the main application file--cfa0:/main.bin!...
............................................................
The main application file is self-decompressing.............................
............................................................................
HP 850 Unified Wired-WLAN JG722A BootWare, Version 1.05
: Aug 14 2013
: XLP432
: 1400MHz
: DDR3 SDRAM
: 4096MB
: 1333MHz
: 768KB
: 16MB
: 3919MB
: 002
: Ver.A
17
*
*
*
Advertisement
Table of Contents
