Maintenance - GoPro SPBL1 Manual

Removing the Door
REATTACHING THE DOOR
1. Line the door up with the small silver bar.
2. Press the door tightly into the small silver bar until it snaps into place
and is securely attached.
WARNING: Be sure that it is locked, sealed, and waterproof
by checking the door latch and pressing the hinge after closing
the door.
104

Maintenance

Follow these tips to get the best performance from your camera:
• Your GoPro is waterproof to 33ft (10m)—no housing needed. Be sure
the door is closed before using it in or around water, dirt, or sand.
• Before closing the door, be sure the seal is free of debris. Use a cloth
to clean the seal if needed.
• Make sure your GoPro is dry and clean before opening the door.
Rinse your camera with fresh water and dry it with a cloth if needed.
• If sand or debris hardens around the door, soak your camera in warm
tap water for 15 minutes and then rinse thoroughly to remove the
debris. Make sure your camera is dry before opening the door.
• For the best audio performance, shake your camera or blow on the
mic to remove water and debris from the microphone holes. Do not
use compressed air to blow into the mic holes. This could damage
the internal waterproof membranes.
• After every use in salt water, rinse your camera with fresh water,
and dry it with a soft cloth.
• The lens cover is made from extremely tough strengthened glass,
but it can still be scratched or cracked. Keep it clean with a soft,
lint-free cloth.
105