Table of Contents
Advertisement
Changing a wash programme
The programme can be changed as long as the Start/Pause
button hasn't been depressed. If the programme has
started, you can only change it by turning the programme
selector to the "Reset" position and cancel the programme.
Select a new programme and press the Start/Pause button.
If you turn the programme selector to another
programme when the machine is running, the
lights in the programme progress display start to
flash. The machine will not perform the new
selected programme.
Interrupting a programme
Press the Start/Pause button to interrupt a programme
which is running. The corresponding light starts to flash.
After approx. 1 minute the door can be opened. The pro-
gramme continues when you press the button again.
Cancelling a programme
Turn the programme selector to the "Reset" position, to
cancel a pre-set programme. Now you can select a new
programme.
Opening the door when the programme
has started
Press the Start/Pause button. The door can be opened
after approx. 1 minute, when the following conditions are
observed:
The water temperature is below 55°C.
●
The water level is below the bottom edge of the door.
●
The machine doesn't spin.
●
If it's absolutely necessary to open the door and the con-
ditions above have been observed, you must switch the
machine off by turning the programme selector to the
"Reset" position. After approx. 1 minute the door can be
opened.
Pay attention that there can be remaining water in
the machine.
At the end of the programme
The machine stops automatically.
When the "End" light is lit, the programme is finished.
The light "Locked" goes out, the door can be opened
and the laundry can be removed.
If the "Rinse hold" option has been selected, the lights
"End" and "Locked" continue to be lit to indicate that the
water must be drained before opening the door.
To drain the water:
1. Turn the programme selector to the "Reset"
position.
2. Select the programme "Draining" or "Spinning".
You can reduce the spin speed by turning the
selector to avoid synthetic, wool or other fragile
materials becoming creased.
3. Press in the Start/Pause button.
4. When the light "Locked" goes out, the door can
be opened and the laundry can be removed.
5. Turn the programme selector to the "Reset"
position.
If you do not intend to carry out any more laundry,
turn off the water supply and for safety reasons,
also disconnect the power supply to the machine.
Leave the door ajar, so that the remaining
moisture inside the drum can evaporate and
prevent any musty smells developing.
- 13 -
Advertisement
Table of Contents
