MULTIQUIP DSGPULW Operation Manual page 8

TRANSPORTING SAFETY
CAUTION
„ ALWAYS shut down the engine before transporting.
„ Drain fuel when trasporting DuoScreed over long
distances or bad roads.
„ NEVER attach a forklift or other lifting device to the lifting
bar. This bar is only for manual lifting on the jobsite.
NOTICE
„ NEVER lift the equipment while the engine is running.
„ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
„ DO NOT lift machine to unnecessary heights.
„ ALWAYS tie down equipment during transport by
securing the equipment with rope or strap.
PAGE 8 — DSGPULW DUOSCREED • OPERATION MANUAL — REV. #8 (06/12/23)
SAFETY INFORMATION
ENVIRONMENTAL SAFETY/DECOMMISSIONING
NOTICE
Decommissioning is a controlled process used to safely
retire a piece of equipment that is no longer serviceable.
If the equipment poses an unacceptable and unrepairable
safety risk due to wear or damage or is no longer cost
effective to maintain (beyond life-cycle reliability) and is to
be decommissioned (demolition and dismantlement), be
sure to follow the rules below:
„ NEVER pour waste or oil directly onto the ground, down
a drain, or into any water source.
„ Contact your country's Department of Public
Works or recycling agency in your area and
arrange for proper disposal of any electrical
components, waste or oil associated with
this equipment.
„ When the life cycle of this equipment is over, remove
the battery and bring it to an appropriate facility for lead
reclamation. Use safety precautions when handling
batteries that contain sulfuric acid.
„ When the life cycle of this equipment is over, it is
recommended that the frame and all other metal parts
be sent to a recycling center.
Metal recycling involves the collection of metal from
discarded products and its transformation into raw
materials to use in manufacturing a new product.
Recyclers and manufacturers alike promote the process
of recycling metal. Using a metal recycling center
promotes energy cost savings.