Advertisement
Install the door glass,
Step 1: Lift the door glass and insert it into the base of the lower beam.
Step 2: Put the door glass in right position and set the upper beam into the rotating shaft
assembly on the top.
Step 3: Lock the screws and set screws.
(Note: Both the upper rotating shaft assembly and the lower base of the door glass can be
adjusted leftwards and rightwards, loosen the screws, adjust them into the appropriate
position and then lock them).
安装门玻，
第一步：将门玻抬起插入下横梁底座；
第二步：摆正门玻，上横梁套入顶部转轴组件；
第三步：锁上螺丝和紧定螺丝。
（注意：门玻上转轴组件和下底座都可以左右调节，松开螺丝，调整合适位置在锁紧即可。 ）
Screw
紧定螺丝 M5×20
Install the handle and the decorative cover.
安装拉手和装饰盖。
ST3.5×40 ×1
Apply the silicone sealant.
打防水胶。
1463408-T01-A
Screw
十字沉头螺丝M4×7×2
Note: Sufficient
support must be
provided when
installing the door
glass.
注意:安装门时需
有足够支撑
Screw
十字沉头螺丝M4×7×2
Note: The top wire of the handle
is facing down.
注意：拉手顶丝朝下。
Note: This position needs to
apply sealant.
注意：此处位置需要打胶。
Install waterproof seal and magnetic strip.
安装防水胶条和磁条。
STEP
7
Install the side seal of the fixed glass (note to distinguish two types of side seals).
安装固玻单边胶条（注意区分两种单边胶条） 。
Note: The height of the two
side seals is 12mm.
注意：此两处单边胶条高度
为 12mm。
STEP
9
STEP
11
-4-
Note: After installation, the magnetic strip is
flush with the waterproof seal.
注意：磁条安装后与回水胶条是平齐状态。
Note: There is a cutout in the side seal, and the
cutout must be flush with the end surface during
installation.
注意：侧边胶条有剪缺，安装时缺口平齐端面即可。
Note: The height of the side seal at
the bottom is 8mm, and it needs to
be attached to the stainless steel
decorative cover during installation.
注意：底部单边胶条高度为 8mm，且
安装时需要贴到不锈钢装饰盖。
STEP
8
STEP
10
Advertisement
