Advertisement
INSTALLATION
Install the tube so that it is horizontal.
放置挡水条，需确保挡水条放置水平。
Install the protective seal at the bottom of the fixed glass and the fixed glass on both sides.
安装固玻底部保护胶条和两侧固玻。
Install the fixed glass profile and the magnetic strip.
1. Insert the magnetic strip into the profile downwards.
2. Pat the whole profile into the fixed glass.
3. The distance from the measured profile to the wall material is about 662mm (the door
glass width is 650mm).
安装固玻型材和磁条。
1. 先将磁条自上而下插入型材；
2. 再将型材整体拍入固玻；
3. 量测固玻之间间距为 662mm 左右（门玻宽度 650mm。
1463408-T01-A
安装
Install the upper-wall profile and the lower beam with the former vertical to the floor and
20mm from the external edge (stone base surface width is 80cm).
安装上墙型材与下横梁，上墙型材需保持与地面垂直，且内偏 20mm 安装（石基面宽
80mm） 。
IMPORTANT:
0mm
Tray MUST be
level along front
edge.
重要：
底盘必须水平。
STEP
1
Install the upper beam which falls into the vertical members on both sides downwards and
whose gap is about 22mm from the side of the wall.
安装上横梁，上横梁自上而下落入两边竖材内，上横梁缺口到墙边尺寸为 22mm 左右。
STEP
3
Install the stainless steel decorative material of the lower beam, the rotating shaft base, the
washer and the silicone bumper block, and install the decorative seal.
安装下横梁不锈钢装饰材、转轴底座、垫圈和硅胶防撞块 , 安装装饰胶条。
STEP
5
-3-
0mm
The wall jamb
must be kept
vertical.
上墙材必须垂直。
Note: There are four M4 thread holes with
each side being locked by one screw.
注意，四个 M4 牙孔，每边能各能锁一个
螺丝即可。
Step 1: Insert the decorative material of the lower beam into the
rotating shaft base in the direction of the arrow.
Step 2: Install the whole part on the lower beam.
Step 3: Adjust the left and right position of the decorative material
of the lower beam and lock by the screws.
Install the decorative seal.
第一步，下横梁装饰材按箭头方向插入转轴底座；
第二步，整体安装在下横梁；
第三步，调整下横梁装饰材左右位置，锁上螺丝。安装装饰胶条。
Note: The fixed glass must be able to
catch the silicone bumper block.
注意：固玻需贴住硅胶防撞块。
STEP
2
STEP
4
Screw
十字沉头螺丝M4×7
Step 1
第一步
Step 2
第二步
Step 3
第三步
STEP
6
Advertisement
