Alarm; Configuring Alarm Settings - Casio 3536 Operation Manual

Alarm

The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
Snooze causes the alarm to sound up to
●
seven times, at five-minute intervals.

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the alarm screen (alarm
number [1] to [4] or [SNZ]) whose setting
you want to change.
Alarm number
Alarm time
Watch Operation Guide 3536
3.
Hold down (A) for at least one second.
Release the button when the hour setting
starts to flash.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to exit the setting screen.
[ALM] (alarm) is shown on the display
●
while an alarm is turned on. [ALM]
(alarm) and [SNZ] (snooze) are shown
while the snooze alarm is turned on.
Alarm hour
Alarm minute
Testing the alarm
●
In the Alarm Mode, hold down (D) to sound the
alarm.
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
Turning Off an Alarm or the Hourly Time
l
Signal
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
The watch will automatically return
●
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
9