Advertisement
Operating Instructions
Set Cooking Level with and without Heat Boost
•
All heaters are equipped with the heat boost function.
•
If the heat boost is required, set the heat from the current level to level 9 by pressing the
button only. Once level 9 has been reached, press
flash "A" alternating with the heat setting value "9" to show the heat boost is active.
•
If the heat boost is active, the heater will operate with maximum power for a period of time
dependent on the heat setting selected before the heat boost was activated.
•
Once the heat boost time has ended, only the heat setting will be indicated on the heater
display.
•
The heat boost can be deactivated by pressing
Switching Off Individual Heaters
A heater can be switched off in 3 different ways:
•
Simultaneous pressing of
•
Reduction of the heat setting to ´0` by pressing the
•
Use of the timer switch-off function for the corresponding heater.
Simultaneous Operation of
•
The corresponding heater must be chosen with the Activate/Deactivate Heater Button
Decimal Point of the related Heater Display will then flash. To switch off the heater,
must be pressed simultaneously. A buzzer will sound and "0" will appear in the heat setting
display when this is successful.
•
If the timer is active for the selected heater, then "0" will appear in the heater and timer displays,
and the related Cooking Zone Indicator and the Timer Function will both switch off.
•
If there is any residual heat for the heater, this will be indicated by an "H" in the heat setting
display.
Reduction of the heat setting to "0" by operating
•
The heater can also be switched off by reducing the heat setting to "0".This will cause the
associated Decimal Point of the heater, the related Cooking Zone Indicator and the Timer
Display to all switch off, also.
•
If there is any residual heat for the heater, this will be indicated by an "H" in the heat setting
display.
Use of the timer switch-off function for the corresponding heater (if available)
•
After counting down to zero, the timer will stop, the corresponding Heater Display will show "0"
and the Timer Display will read '00'. The corresponding Cooking Zone Indicator will disappear.
•
An assigned Dual/Triple Zone Selection Indicator will also disappear if it is active.
•
Additionally, the buzzer will sound when the timer stops. Pressing any button will silence the
timer.
Key Lock
The key lock function is used to set 'safe mode' on the appliance and can only be used in Operating Mode
(B-Mode). The lock function becomes active when the key Lock button
This operation is acknowledged by a buzzer and the Key Lock Indicator will flash to indicate the heater is
locked.
If the heater is locked, it will only be possible to switch the appliance off by pressing
blocked and it will not be possible to make any adjustments by pressing the buttons. If any other button is
pressed in the lock mode, the buzzer will sound and the Key Lock Indicator will flash.
Only the switch-off operation by pressing
be restarted again without being unlocked.
and
buttons.
and
Buttons
is possible. However, if the appliance is switched off, it cannot
9
to activate the heat boost. The display will
until the heat setting "0" is displayed.
button.
button
is pressed for at least 2 seconds.
, the
and
, all other buttons are
Advertisement
