Table of Contents
Advertisement
87
r ip mode!
88
s ip mode 1!
89
r ip addr!
90
s ip addr 192.168.1.255!
91
r subnet!
92
s subnet 255.255.255.252!
r gateway!
93
94
s gateway 192.168.1.1!
95
r port!
96
s port 8000!
97
r sleep time!
98
s sleep time 1!
99
r osd time!
100
s osd time 1!
5.9 Web GUI Control
The switcher can be controlled via Web browser, which contains General, Setup and Network Settings.
After the active Ethernet link with an RJ45 terminated cables are connected, the IP address is obtained
and the IP address is entered in the Web browser, the switcher can be controlled. If IP address is
unknown, there are two methods to obtain the IP address.
1. Obtain the IP address and port number via the information from the MENU-> Network OSD by the
remote control.
2. Obtain the IP address and port number via RS-232 Controller.
For example, the obtained IP address is 192.168.1.100 and port number is 8000.
Input http://192.168. 1.100 in the address bar of the web browser.
Read IP mode
Setup IP mode at Static (1:Static,2:DHCP)
Read IP address
Setup IP address at 192.168.1.255
Read subnet
Setup subnet at 255.255.255.252
Read gateway
Setup gateway at 192.168.1.1
Read control port
Setup control port at 8000
Read switcher sleep time(no signal to standby mode time)
Set switcher sleep time(no signal to standby mode time)
(1: OFF , 2: 15seconds, 3: 1minutes ,4: 5minutes,
5:15minutes, 6: 60minutes)
Read OSD time out
Set OSD time out
(1: 5seconds, 2: 10seconds,3: 15seconds ,
4: 20seconds, 5: 25seconds , 6: 30seconds )
26/31
Advertisement
Table of Contents
