Table of Contents
Advertisement
2) Control local device from remote
To control the switcher or local source device by using the corresponding
remote controller.
DVD
3) IR(20KHz---60KHz) cable introduction
5.5 Auto-Switching function
The switcher has auto-switching and manual-switching modes. When the user
select auto-switching mode, It will follows the following principles:
5.5.1.Newinput principle
Once a new input signal is detected, the switcher will switch to this new signal
automatically.
5.5.2. Power rebooting principle
The switcher offers the function to remember the signal last used before
power off. Once rebooted, it will automatically enter auto-switching mode,
and then detect all inputs and memorize their connection status for future
reboots. If the last used input signal is still available, then it will choose that
signal. If not, it will detect all input signals with priority on HDMI1->HDMI2->
HDMI3->DP->VGA (YPbPr/CVBS).
TX
Scaler switcher
UTP Cable
17/31
TX 1
RX
DVD Remote
Scaler switcher Remote
Advertisement
Table of Contents
