Table of Contents
Advertisement
ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
DDR3 DIMM slots
Install 4 GB and 8 GB unbuffered non-ECC DDR3/DDR3L DIMMs into these DIMM
sockets.
Intel
®
The motherboard comes with an onboard Intel
and a specially designed CPU heatsink.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
Speaker connector (4-pin SPEAKER)
The 4-pin connector is for the chassis-mounted system warning
speaker. The speaker allows you hear system beeps and warnings.
1-2
•
For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 350 W.
•
If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended Power Supply Wattage Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors! The CPU_FAN
connector supports a CPU fan of maximum 1A (12 W) fan power.
For more details, refer to System memory.
Celeron
Quad Core Processor J3455
®
For more details, refer to Central Processing Unit (CPU).
Celeron™ Quad Core Processor
®
Chapter 1: Product introduction
SPEAKER
PIN 1
Advertisement
Table of Contents
