Table of Contents
Advertisement
en Drying
Press
" Descaling".
2.
The duration cannot be changed.
Press
.
3.
a A notification stating that you should carry out the
necessary preparatory work for descaling appears
on the display.
Confirm the message.
4.
a The descaling programme starts and the duration
counts down.
a Once the first part of the descaling programme has
finished, a signal tone sounds. The appliance
prompts you to rinse twice.
20 Drying
To prevent residual moisture , dry the cooking compart-
ment following operation with steam and after using the
cleaning aid.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
20.1 Drying the cooking compartment
You can leave the cooking compartment to dry or use
the drying function.
Allow the appliance to cool down.
1.
Remove any dirt from the cooking compartment.
2.
Wipe away any water in the cooking compartment.
3.
Dry the cooking compartment.
4.
To dry the cooking compartment, leave the appli-
‒
ance door open for 1 hour.
21 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
Note: Wipe the condensate trough without pressure.
21.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Open the appliance door fully.
1.
28
To rinse the appliance, for each rinse cycle:
5.
Open the control panel and remove the water
‒
tank.
Thoroughly rinse the water tank and fill it with
‒
fresh water.
Slide in the water tank and close the control
‒
panel.
a A signal tone sounds when each rinse cycle has
ended.
Once the second rinse cycle is complete:
6.
Empty and dry the water tank.
‒
→ "Emptying the water tank", Page 18
Press
to switch the appliance off.
‒
To use the drying function, set "Drying function".
‒
→ "Setting the drying process", Page 28
Setting the drying process
Requirement: → "Drying the cooking compartment",
Page 28
Press "Cleaning" in the menu.
1.
Press
"Drying function".
2.
The duration cannot be changed.
Press
.
3.
a A notification stating that you should carry out the
necessary preparatory work for the drying appears
on the display.
4.
Confirm the message.
a The drying process starts and the duration counts
down.
a Once the drying has ended, a signal tone sounds. A
message appears on the display confirming that the
operation has finished.
Press
to switch the appliance off.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for 1 to 2 minutes.
Advertisement
Table of Contents
