Honda CBR1000RR 2018 Owner's Manual page 154

Engine Oil Changing Engine Oil & Filter
u
Remove the oil filter with a filter wrench
7.
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
u
approved recycling centre.
Rubber
seal
Apply a thin coat of engine oil to the
8.
rubber seal of a new oil filter.
150
Install the new oil filter and tighten.
9.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Install a new sealing washer onto the
10.
drain bolt. Tighten the drain bolt.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Fill the crankcase with the recommended
11.
oil (
cap.
Required oil
When changing oil & engine oil
filter:
2.7 L (2.9 US qt, 2.4 Imp qt)
When changing oil only:
Oil filter
2.5 L (2.6 US qt, 2.2 Imp qt)
Check the oil level.
12.
Check that there are no oil leaks.
13.
Install the under cowl.
14.
P. 132, P. 219) and install the oil fill
2 2
P. 147
2