Installing The Internal Antenna Kit - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual

Steps
1. Remove the two screws (M3x3) that secure the internal antenna kits to the chassis.
2. Remove the internal antenna kits from the chassis.
3. Unroute the internal antenna kit cable from the routing guides on the chassis
4. Gently pull the internal antenna kit cable out from the hole on the chassis.

Installing the internal antenna kit

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the internal antenna kit and provides a visual representation of the installation
procedure.
Wymontowywanie i instalowanie modułów wymienianych na miejscu (FRU) 87