Steps
1. Disconnect the system-fan cable from the connector on the system board.
2. Gently pull the top rubber grommets to release the fan from the chassis.
NOTE:
The rubber grommets must be re-used during system fan replacement.
3. Slide and push the bottom rubber grommets through the holes on the chassis.
4. Remove the system fan off the chassis.
Instalowanie wentylatora systemowego
OSTRZEŻENIE:
Informacje zawarte w tej sekcji są przeznaczone wyłącznie dla autoryzowanych techników
serwisowych.
Wymagania
W przypadku wymiany elementu przed wykonaniem procedury instalacji wymontuj wcześniej zainstalowany element.
Informacje na temat zadania
Na ilustracji przedstawiono umiejscowienie i procedurę instalacji wentylatora systemowego.
Wymontowywanie i instalowanie modułów wymienianych na miejscu (FRU)
77