Transmission Methods For Scan To E-Mail - Sharp FO-2081 Operation Manual

TRANSMISSION METHODS FOR SCAN TO E-MAIL

The e-mail address for a Scan to E-mail transmission can be entered manually or
selected from e-mail addresses stored on an LDAP server.
Sending an image by entering an e-mail address manually
1
Press the [MODE SELECT] key to select
scanner mode.
The "SCAN" indicator lights up to indicate that
scanner mode is selected.
2
Make sure that the "SCAN USING: USB/
NETWORK" is shown on the display. Then
press [OK] to enter Scan to USB and
Network Scan mode.
(The initial display will be "SCAN USING: SCAN
TO USB".)
3
Place the original in the document feeder tray or on the
document glass.
For information on how to place the original, see "Image orientation and
standard original loading orientation" (p.123).
4
Select "INPUT ADDRESS" using the [
key (
the [OK] key.
If "INPUT ADDRESS" does not appear, make sure
that "Scan to ad-hoc E-mail" is enabled in the Web
page (p.113).
5
Enter the destination e-mail address and
press the [OK] key.
To enter characters, see "How to enter characters"
(p.124).
6
Press the [
size and then press the [OK] key.
The original size changes as follows each time the [
key (
"8.5x11" → "8.5x5.5" → "A4" → "B5" → "A5" → "8.5x14" → "8.5x13"
(when AB (metric) default setting: "A4" → "B5" → "A5" → "8.5x14" →
"8.5x13" → "8.5x11" → "8.5x5.5".)
120
) or [ ] key (
] key ( ) or [
) is pressed:
]
) and then press
] key ( ) to select the original
SCAN USING:
USB/NETWORK
SCAN USING:
INPUT ADDRESS
INPUT ADDRESS:
XXXXX.XXXXX.com
] key ( ) or [ ]