Connecting To A Computer; Input 1 Terminal 23·25 - Sharp XG-MB70X Operation Manual

Connecting to a Computer

Before connecting, ensure the power cord of the projector from the AC outlet is unplugged,
and that the devices to be connected are turned off. After making all connections, turn on the
projector and then the other devices. When connecting a computer, ensure that it is the last
device to be turned on after all the connections are made.
Ensure the operation manuals of the devices to be connected have been read before making connections.
To USB terminal
To audio output terminal
To RGB output terminal
* When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable.
Note
• When connecting with USB cable, you can use the remote control as a mouse for controlling the cursor.
See page 24.
• See page 69 "Computer Compatibility Chart" for a list of computer signals compatible with the projector.
Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest
Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the signal
output setting of the computer is switched to the external output. Refer to the computer operation
manual for switching the computer signal output settings.
"Plug and Play" function (when connecting to a 15-pin terminal)
■ This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA DDC com-
patible computer will communicate their setting requirements, allowing for quick and easy setup.
■ Before using the "Plug and Play" function, be sure to turn on the projector first and the connected
computer last.
Note
• The DDC "Plug and Play" function of this projector operates only when used in conjunction with a VESA
DDC compatible computer.
Computer
To INPUT 1
terminal
RGB cable
*
ø3.5 mm stereo or mono audio cable
(commercially available or available as Sharp service part QCNWGA038WJPZ)
Supplied
accessories
To AUDIO
To USB terminal
INPUT 1, 2 terminal
RGB cable
USB cable
USB cable
Connect to use the remote control
as a wireless computer mouse.
-23