Table of Contents
Advertisement
TOP VIEW
REMOTE CONTROL SIGNAL
TRANSMITTER
WIRED REMOTE CONTROL
INPUT (3.5 mm Minijack)
Laser light shines out of this window.
"COMPLIES WITH 21 CFR SUBCHAPTER J"
CAUTION
SHARP ELECTRONICS CORPORATION
SHARP PLAZA, MAHWAH, NEW JERSEY 07430
TEL : 1-800-BE-SHARP
LASER RADIATION-
DO NOT STARE INTO BEAM
REMOTE CONTROL
MODEL NO. : G1414CESA
WAVE LENGTH : 670nm
DC6V (1.5VX4PCS.)
MAX. OUTPUT : 1mW
MADE IN JAPAN
CLASS II LASER PRODUCT
FABRIQUÉ AU JAPON
REAR VIEW
Press in and
downward on
the arrow
mark and
remove.
Transmission range
30°
Max. distance: 23 (7 m)
30°
E-7
LASER LIGHT WINDOW
U.S.A. ONLY
Insert the side
tabs into their
slots and
press in the
cover until
properly
seated.
Reception range
30°
45°
Using the optional cable with the remote control
When the remote control cannot be used due to the
range or positioning of the projector (rear projection,
etc.), connect the optional cable from the Wired Remote
Control Input jack on the remote control to the Wired
Remote Input on the rear of the projector.
Note:
• The signal transmitter does not function when the optional
cable is connected to the remote control.
The laser pointer on the remote control
emits a laser beam from the laser light win-
dow shown in the figure to the left. The laser
emitted is a class II laser; therefore, do not
look into the laser window or shine the laser
beam on yourself or other people. The two
marks to the left are the caution labels for
the laser beam.
Always use the laser pointer at tempera-
tures between 41°F and 104°F ( 5°C and
40°C).
Inserting the batteries
Remove the battery cover as shown and insert four AA
size batteries making sure their polarities match the ( )
and ( ) marks inside the battery compartment.
Notes:
Incorrect use of batteries may cause them to leak or burst.
• Insert the batteries with the ( ) and ( ) polarities as indi-
cated.
• Remove the batteries if the remote control will not be oper-
ated for an extended period of time.
• Maintain the batteries in a clean condition.
• Do not mix different brands of batteries. The life expectancy
of the new batteries will be shortened and the old batteries
may leak.
• When the batteries have been used up, remove them imme-
diately to prevent leakage and damage. Leaked battery fluid
may irritate the skin. Remove any battery fluid by wiping with
a cloth.
• Due to storage conditions and the shelf life of the supplied
batteries, they may run out after a short time. If so, replace
them with new batteries as soon as possible.
Remote control positioning
Use the remote control as shown in the figures on the left.
Note:
• The signal from the remote control can be reflected off the
screen for easy operation. However, the effective distance of
the signal may differ due to the screen material.
Advertisement
Table of Contents
