Mounting On Linear Actuators - ABB cFMus TZIDC-200 Manual

20 TZIDC-200 DIGITAL POSITIONER | CI/TZIDC-200/C-FM-US-EN REV. B
... 5 Installation
... Mechanical mounting

Mounting on linear actuators

For mounting on a linear actuator in accordance with DIN /
IEC 60534 (lateral mounting as per NAMUR), the following
attachment kit is available.
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin (for travel
10 to 35 mm (0.39 to 1.38 in) or
20 to 100 mm (0.79 to 3.94 in)
5 Washers
6 Screws
Figure 5: Components of attachment kit
7 U-bolt
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
Figure 6: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws 4 and spring washers
Figure 7: Assemble lever (if not pre-assembled)
1. Insert spring 8 on bolt with follower pin
2. Slip the plastic washer 7
spring with it.
3. Insert the bolt with compressed spring into the oblong hole
in the lever 6 and fasten it in the desired position using the
plain washer 5 and nut
lever indicates the link point for the stroke range.
4. Place the washer 2 on the screw
lever and lock with the nut
1 and clamp plates 2 with
3 to the actuator stem.
9 .
onto the bolt and compress the
4 at the lever. The scale on the
1 . Insert the screw in the
3 .