Mounting On Linear Actuators - ABB TZIDC-200 Operating Instruction

16 TZIDC-200 DIGITAL POSITIONER | OI/TZIDC-200-EN REV. C
... 6 Installation
... Mechanical mounting

Mounting on linear actuators

For mounting on a linear actuator in accordance with DIN / IEC
534 (lateral mounting as per NAMUR), the following attachment
kit is available:
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin
(for mechanical stroke
10 to 35 mm [0.39 to 1.38 in] or
20 to 100 mm [0.79 to 3.94 in])
5 Washers
6 Screws
Figure 6: Components of attachment kit
7 U-bolt
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
Figure 7: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws and spring washers
4
Figure 3: Assemble the lever (unless pre-assembled)
1. Insert spring on bolt with follower pin
8
2. Slip the plastic washer
7
spring with it.
3. Insert the bolt with compressed spring into the oblong hole
in the lever and fasten it in the desired position using the
6
plain washer and nut
5
lever indicates the link point for the stroke range.
4. Place the washer on the screw
2
lever and lock with the nut
and clamp plates with
1 2
to the actuator stem.
3
.
9
onto the bolt and compress the
at the lever. The scale on the
4
. Insert the screw in the
1
.
3