Head Restraints - Second Row Quad Seats; Head Restraints - Second Row Bench; Head Restraints - Third Row - Dodge GRAND CARAVAN 2019 User Manual

Head Restraints — Second Row Quad Seats
The head restraints on the second row quad
seats are non-adjustable and non-removable.
The head restraint will automatically fold for-
ward when the seat release lever is pulled dur-
ing the Stow n' Go procedure. Refer to "Seats"
in this section for further information.
Head Restraints — Second Row Bench
The second row bench seat is equipped with
adjustable head restraints.
To raise the head restraint, pull upward on the
head restraint. To lower the head restraint, push
the adjustment button, located at the base of
the head restraint, and push downward.
To remove the head restraint, raise it as far as it
can go. Then, push the release button and the
adjustment button at the base of each post
while pulling the head restraint up. Seatback
angle may need to be adjusted to fully remove
the head restraint. To reinstall the head re-
straint, put the head restraint posts into the
holes and push downward. Then, adjust the
head restraint to the appropriate height.
20
WARNING!
• A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head re-
straints in a location outside the occupant
compartment.
• ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect
the occupants. Follow the re-installation
instructions above prior to operating the
vehicle or occupying a seat.
NOTE:
For child restraint tethering, refer to "Occupant
Restraint Systems" in "Safety" for further infor-
mation.
Head Restraints — Third Row
The outboard head restraints can be manually
folded forward for improved rearward visibility.
They are non-removable. Pull the release strap
to fold them forward.
NOTE:
• The head restraints must be raised manually
when occupying the third row.
• Do not fold if there are passengers seated in
the third row seats.
The head restraint in the center position can be
raised and lowered for tether routing or height
adjustment. Refer to "Occupant Restraint Sys-
tems" in "Safety" for further information.
NOTE:
To remove the center head restraint, raise it as
far as it can go. Then, push both the release
button and the adjustment button at the base of
each post while pulling the head restraint up. To
reinstall the head restraint, put the head re-
straint posts into the holes and push downward.
Then, using the adjustment button, adjust the
head restraint to the appropriate height.