Door Reversal - Hyundai FSB 050 WW8 User Manual

Door Reversal

This refrigerator has been built with the door hinges on the right. If you wish
to change the opening direction, follow the instructions below:
1. Remove the upper hinge cover(6) first
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame. Take away
the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and Make sure to Remove the lower
hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate(7) to the right side.
7 . Before placing this lower hinge(2), remove the bolt-pin (9) and reverse the direction of the
lower hinge(2). Then install the lower hinge (2) onto the left side of the lower frame with two
screws (8).
8. Insert the bolt-pin(9) to the lower hinge (2).
9. Set the door to its place making sure the door seat at the lower hinge(2)
10. While holding the door in the closed position secure the upper hinge (5) in the top frame of left
side with two screws (1). Please remember that do not tighten the two screws(1) until the top
of the door is levelled with the counter top.
11. Install the upper hinge cover(6) on the upper hinge..
FIGURE 1 – REPRESENT POSITION OF COMPONETS PRIOR TO DOOR REVERAL.
FIGURE 2 – REPRESENT POSITION OF COMPONETS AFTER DOOR REVERAL.
EN - 21
EN