System Connections - Sharp DK-A10P Operation Manual

System connections

DK-A10P
DK-A10P (BK)
Make sure to unplug the AC power cord before making any
connections.
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS jack and position the
FM antenna wire in the direction where the strongest signal can be
received.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM and GND terminals. Position
the AM loop antenna for optimum reception. Place the AM loop antenna
on a shelf, etc., or attach it to a stand or a wall with screws (not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may cause
noise pickup. Place the antenna away from the unit for better reception.
Installing the AM loop antenna:
< Assembling >
Outdoor FM antenna
Use an outdoor FM antenna if you require better reception.
Consult your dealer.
75 ohms
coaxial cable
10
< Attaching to the wall >
Wall Screws (not supplied)
Outdoor FM antenna
Note:
When an outdoor FM antenna is used, disconnect the supplied FM
antenna wire.
Connecting iPod to TV
iPod with photo and video can be view by connecting to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT
jack on the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL to match
your TV signal. Please visit Apple's home page for further
information.
AC power connection
After checking all the connections have been made correctly, plug
the AC power cord of this unit into the AC outlet. If you plug in the unit
first, the unit will enter the demonstration mode.
To AC input
Note:
Unplug the AC power cord from the AC outlet if the unit will not be in
use for a prolonged period of time.
TV
Video cable
(not supplied)
To video
input jack
AC outlet
(AC 120 V ~ 60 Hz)