Table of Contents
Advertisement
Throttle neutral adjustments can
be made moving the throttle
trim up or down.
Racers Tip
When using an electronic speed control, set the throttle trim
to neutral and make adjustments to the speed control. On
a gas powered model, set the trim to neutral and adjust the
linkage to the point where the carburetor is fully closed in
accordance with the engine instruction manual.
Trim Operation and Maximun Travel
on the maximum servo travel. This prevents the linkages
from binding when adjustments are made.
When trim movement is extreme
If you use most of the trim movement to get the servo to the
neutral position, recenter the servo horn closer to the neutral
position and inspect your throttle linkage.
Channel-4 Trim （ TRM-CH4 ）
(This setting screen is displayed when 4WS mixing or Brake mixing is activated.)
At 4WS mixing function:
The neutral adjustments of
the rear steering servo can
be made by pressing the
+/‑ key.
At brake mixing function:
The neutral adjustments of the front
brake servo can be made by pressing
the +/‑ key.
Use this function to adjust the neutral
position of the steering, throttle and
channel 3 (4) servos.
Subtrim shifts the entire servo travel range
in the set direction.
*CH4 setting screen is displayed when 4WS mixing
or Brake mixing is activated.
Use this function to adjust the steering
travel of your model. When the steering
angle is too large at over steering, decrease
the rate. The setup here is linked with
transmitter grip lever DT3. Adjustments
can be made at this screen even if DT3 is
assigned to another function.
18
Throttle Trim （ TRM-CH2 ）
Throttle Trim
Channel-4 Trim
(4WS mixing)
SUB Trim （ CH1-CH4 ）
Steering Dual Rates （ D/R ）
Trim change
(F100〜0〜B100)
Press Trim
Reset
Carburetor Fully Closed
+
-
and
Press and hold
Reset
Trim change
*It can't be used in R203GF.
SUB Trim
Ｃ Ｈ １ to Ｃ Ｈ4
Select by
Ｒ ： Right Ｌ ： Left
Ｆ ： Forward Ｂ ： Brake
*CH4 can't be used in R203GF.
D/R
Press
Reset
DT3
+
-
and
Press and hold
Reset
or
Trim change
(Drum Type)
(Slide Type)
(Brake mixing)
+
-
and
Press and hold
Reset
key
SUB Trim change
+
-
and
Press and hold
Reset (100%)
or
Steering rate change
Advertisement
Table of Contents
