3Pv-2.4G Functions; Model Selection/Model Reset (Mdl); Model Name (Mdl Name); Low Battery Alarm (Lba) - FUTABA FUT3PVR314SB Instruction Manual

3 (+1) channel, t-fhss radio control system for cars

Hide thumbs

Table Of Contents

Table of Contents

Model Selection ／ Model Reset （ MDL ）

The model selection selects the desired model memory from the 10 model memories stored

Model Selection

Model number

（1 - 0）

Model name

T h i s f u n c t i o n p r o v i d e s a

4-character name for each of the

model memories in the transmitter

to easily select the correct setup

for the model currently in use.

• Clearly label each model for easy

selection.

Select the battery alarm voltage

according to the battery to be used.

*The voltage drop of a rechargeable battery

and a dry cell battery is different. When

using a rechargeable battery, always change

the voltage.

4 dry cell batteries ⇒ 4.2V

HT5F1800B (5cell NiMH battery) ⇒ 5.0V

FT2F1700BV2/FT2F2100BV2 (2cell LiFe battery) ⇒ 5.8V

System changes (T-FHSS, S-FHSS,

F H S S , T- F H S S < H i g h - S p e e d > )

matched to the receiver type.

When the system was changed and

when a model of a different system

was selected, signal are output in the

system set at the point at which the

transmitter power was turned back on.

R314SB/R304SB − T-FHSS (TFH), T-FHSS High-Speed (TFH-HS) : The voltage of the receiver is shown to a transmitter.

R203GF −−− S-FHSS (SFH), FHSS (FH)

When using the T3PV in the T-FHSS High-Speed mode, always use it under the following conditions:

Servos

:Futaba digital servo (including BLS Series brushless servos)

Receiver's battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery can-

not be used).

Under other conditions, the set will not operate, or the speciﬁed performance will not be displayed even if it

operates. In addition, it may cause servo trouble.