Transmitter Set-Up Procedures - FUTABA FUT3PVR314SB Instruction Manual

Transmitter Set-Up Procedures

*When making these setting adjustments, do so with the motor disconnected or the
engine not running.
(Preparations)
Select the model memory that is not used and reset it to the initial values with the model
selection and model reset functions.
Model Selection
Model number
（1 - 0）
Model name
Servo Horn Installation Instructions
1 Connect the receiver, servos, and other components and then turn
on the power switches to the transmitter and receiver.
*Both servos will move to the neutral position.
2 At this time install the servo horn in the manner described in the
instruction manual provided with the model this system will be used in.
Reversing The Servo Operation Direction
Should the servo operate in the opposite direction required for your application,
reverse the direction with the servo reversing.
Steering Servo Reverse
NOR: Normal
REV: Reverse
E.S.C. MC231CR / MC331CR
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Set the throttle adjustment function (EPA) to 100% and
the ABS function to OFF using the transmitter throttle
channel function.
If the throttle angle is too large or the ABS functions are on,
erroneous operation may occur.
Before setting each point, set the transmitter throttle channel trim to neutral.
1
Turn on the power in transmitter -> amp order.
Transmitter throttle operation
2
Neutral point
setting
3
High point
setting
Full High
4
Brake MAX
point setting
Model Reset
Push the DT1 lever right or left
for about two seconds.
All data stored in the currently
selected model memory is
erased.
Selection key
Direction change
(Pushbutton switch operation)
･Press the pushbutton switch.
･Neutral state
(Confirmation beep sounds)
N
･Press the pushbutton switch.
･Full high state
(Confirmation beep sounds)
N
･Press the pushbutton switch.
･Full brake state
(Confirmation beep sounds.)
Full brake
N
Throttle Servo Reverse
NOR: Normal
REV: Reverse
*When using the ABS function,
after setting up the MC231CR /
MC331CR, stop the reverse
function, then turn on the ABS
function. If the ABS function is
on, the MC231CR / MC331CR
cannot be set up correctly.
MC231CR /MC331CR
(Checker LED)
･Continuous single blink
(0.5 secs or longer)
･Continuous double blink
･If the LED goes out,
setting is complete.
Direction change
15