Receiver and Servo Connection
As you connect the receiver, servos and other components, do so in accordance with the
"Assembly Precautions".
Installation When An Electronic Speed Control Is Used
e.g. R314SB
Installation For Gas Powered Models
e.g. R314SB
Receiver
To Battery
Receiver Antenna Installation
Install the R203GF/R304SB/R314SB receiver on the car as follows:
Note: The operating range may become shorter, depending on where the
receiver and the antenna are mounted.
WARNING
Install the antenna in the higher place as shown in the figure.
Keep the antenna as far away from the motor, ESC and other
noise sources as possible.
Put the antenna in the antenna tube to protect it.
Do not cut the antenna.
Do not bend the coaxial cable. Doing so causes damage.
12
Assembly / Adjustment
CH3
CH4
CH1
CH2
B/C
Switch
CH4 servo
CH3 servo
Throttle servo
Steering servo
Antenna
tube
Antenna
Coaxial
cable
Receiver