Displayed Messages - AEG KKK994500 User Manual

15. DISPLAYED MESSAGES

Displayed message
FILL WATER TANK
EMPTY GROUND CONTAINER
INSERT GROUND CONTAINER
ADD PRE-GROUND COFFEE
FILL BEAN CONTAINER
GROUND TOO FINE. ADJUST
GRIND LEVEL
Possible cause
Insuicient water in the tank
(A6).
The ground container (A1) is ull.
Ater cleaning, the ground
container (A1) has not been
replaced.
The "pre-ground coee" unction
has been selected without plac-
ing any pre-ground coee in the
unnel (A11).
The pre-ground coee unnel
(A11) is clogged.
The coee beans have run out.
The grinding is too ine and the
coee is delivered too slowly or
not at all.
I the sotener ilter (B4) is
present, an air bubble may have
been released inside the circuit,
obstructing delivery.
ENGLISH
Remedy
Fill the tank with water and/
or insert it correctly, push-
ing it as ar as it will go until
it clicks into place.
Empty the ground container
and drip tray (A8), clean
and replace. Important:
when removing the drip
tray, the ground container
must be emptied, even
i it contains only a ew
grounds. I this is not done,
the ground container may
overill and clog the ma-
chine as the user continues
to prepare coees.
Remove the drip tray (A8)
and insert the ground
container.
Place pre-ground coee
in the unnel and repeat
delivery
Empty the unnel with the help o
a brush (B5), as described in the
section "Cleaning the pre-ground
coee unnel".
Fill the beans container (ig.
9 Quick Guide).
Repeat coee delivery
and turn the grinding
adjustment dial one click
clockwise towards "7" while
the coee mill is in opera-
tion. I ater making at least
2 coees delivery is still too
slow, repeat the correc-
tion procedure, turning the
grinding adjustment dial
another click until delivery
is correct (see section "Ad-
justing the coee mill"). I
the problem persists, make
sure the water tank (A6) is
ully inserted.
Insert the hot water/steam
spout (B6) in the appliance
and deliver a little water
until the low becomes
regular.
23