Before First Use - AEG KKK994500 User Manual

10 www.aeg.com

BEFORE FIRST USE

5.
5.1 Controls after transport
Ater removing the packaging, check
that the appliance is intact and that all
accessories are included. Do not use the
appliance i it is visibly damaged. Contact
Customer Services.
5.2 Initial cleaning
Coffee has been used to factory-test the
appliance and it is therefore completely
normal for there to be traces of coffee in
the grinder.
Customise water hardness as
soon as possible ollowing the
instructions in the "Setting water
hardness" section.
5.3 Installing the appliance
IMPORTANT!
• Installation must be perormed by a
qualiied proessional in compliance
with legislation in orce in the country
o installation (see Built-in installation).
• The packing elements (plastic bags,
polystyrene oam, etc.) should be kept
out o reach o children.
• Do not install the appliance in rooms
where the temperature may drop to
0°C or lower.
• Customise the water hardness as soon
as possible ollowing the instructions in
the "Setting water hardness" section.
5.4 First connection
Connect the appliance to the mains
electricity supply and make sure the main
switch (A10) on the side o the appliance
is pressed down (ig. 1);
Turn the rotary (C2) (ig. 2 Quick Guide)
to select the required "Language", then
press the rotary to conirm;
Turn the rotary again to select "Display
Brightness" and press it to conirm. Turn
the rotary to set rom 1 to 5 level.
Turn the rotary to select "Time o day"
and press it to conirm. Turn the rotary to
select "Minute o the day" and press it to
conirm. Turn the rotary to set the hours
and minutes until the current time is
displayed and press it to conirm.
Turn the rotary to select "demo mode" or
"First use".
First use setup:
• FILL WATER TANK is displayed:
remove the water tank (A6), open the
lid, ill to the MAX line (marked on the
inside o the tank) with resh water (ig.
4 Quick Guide), close the lid and put
the tank back in the appliance;
• INSERT THE WATER SPOUT is
displayed: Check that the hot water/
steam spout (B6) is inserted on the
connection nozzle (A5) (ig. 5 Quick
Guide) and place a container holding a
minimum o 100 ml underneath;
• PLACE A CUP (at least 100ml) UN-
DER THE WATER SPOUT PRESS
OK TO START DELIVERING HOT
WATER appears on the display;
• Select OK to conirm. The appliance
delivers water rom the spout then
ig. 1