Advertisement
USING THE CONTROL PANEL
PROGRAMS:
START/STOP BUTTON
Press Start/Stop button once to activate the 30-second blend cycle.
POWER BUTTON
Press Power button to turn unit ON and OFF.
TROUBLESHOOTING
LED Shows
Vessel and Base are Not Aligned
Flashing WHITE
Blades are Blocked
Flashing ORANGE
Needs Charge
Solid RED
Abnormal charger
Flashing RED and BLUE
Unit Cool Down Time Out
Clockwise-moving ORANGE LEDs
While Charging
Flashing WHITE and RED
Flashing RED in the bottom left
While Blending
and top right
USING THE BLENDING VESSEL
IMPORTANT: Review all warnings at the beginning of this Owner's Guide before proceeding.
1
Ensure the motor base is fully charged and the vessel is properly installed
by aligning vessel arrow with motor base arrow located on the back of the
motor base.
2 Turn unit ON by pressing the
lights illuminate.
3 Add ingredients, starting with liquids then solid ingredients. If using ice,
always add last. DO NOT fill ingredients past the MAX FILL line. Secure
lid onto the vessel, twisting clockwise to tighten.
4 Blend for a 30-second blend cycle by pressing the Start/Stop button.
ninjakitchen.com
Solutions
Ensure vessel and motor base are
aligned using the arrows on the back
of motor base and vessel.
Move lodged ingredients from blade
& restart blend program.
Charge unit.
Defective charger, unplug & find correct
5V 3A charger.
Let unit sit at room temp for 15 minutes
before using again.
Call Customer Service.
Call Customer Service.
button until Start/Stop button
5 Open the sip lid to sip, or remove the lid to pour out blender outputs
into another container. DO NOT remove vessel from motor base when
filled. Empty vessel prior to removing from motor base.
6 After blending, power OFF the unit by pressing the
Motor base should be turned OFF when drinking from the sip lid
and when blender is no longer in use.
7 Refer to the Care & Maintenance section for cleaning and
storage instructions.
CARE & MAINTENANCE
CLEANING
Blades can still operate when the lid is removed. Always turn the unit OFF when cleaning without the lid on
or when the BlastBlade™ Assembly is exposed.
Hand-Washing
Wash vessel, lid, and BlastBlade™ Assembly with warm, soapy water. Use a dishwashing utensil or cloth
to clean the BlastBlade™ Assembly on the motor base. Exercise care when handling the BlastBlade™
Assembly on the motor base as the blades are sharp. Wipe the motor base with a clean, damp cloth.
DO NOT submerge the motor base in water. Thoroughly rinse and air-dry all appropriate parts.
Motor Base
The USB-C port and the Motor Base are is water resistant, which means the motor base can get rinsed
in the sink; HOWEVER DO NOT put the motor base in the dishwasher or submerge it in water. Ensure the
USB-C charger is not inserted before cleaning.
DEEPER CLEAN
Dishwasher
Vessel and sip lid are top-rack dishwasher safe. DO NOT use a heated dry cycle. Ensure the vessel
and sip lid are removed from the motor base before being placed in the dishwasher.
STORING
Store the unit upright and with the lid, vessel, and motor base fully assembled.
DO NOT store blended or unblended ingredients in the vessel with the BlastBlade™ Assembly
for prolonged periods of time.
DO NOT stack items on top of the vessel. Store any remaining attachments alongside the unit
or in a cabinet where they will not be damaged or create a hazard.
If your unit needs servicing, call Customer Service at 1-877-646-5288. So we may better assist you, please
register your product online at registeryourninja.com and have the product on hand when you call.
ORDERING REPLACEMENT PARTS
To order additional parts and attachments, visit ninjaaccessories.com.
button.
ninjakitchen.com
Advertisement
